Hello There, Guest! Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to cut the lace in the front
11-06-2008, 07:59 PM,
#1
How to cut the lace in the front
Hi,

Does anyone know any tips on how to cut the lace part on a new unit (Yes, I know with a scissors) off without screwing it up. Just received a 68% Tl100. It seems kinda thin in density but then again they all do to me until there on. TheThinnist base I've ever seen on a unit. Been to Hcm and H-Direct and thought I'd give top lace a try. Took awhile to get the hair though.
Reply
11-07-2008, 04:51 AM,
#2
Re: How to cut the lace in the front
I turn the base upside down and pin it onto a styro head, I then take very sharp manicure scissors and trim off the extra lace leaving 1/8th to 1/4 inch in the front.
just be careful to not cut the hair, just cut the lace....but it is not hard to do at all.
DebbieS.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)