Hello There, Guest! Register

Thread Rating:
  • 1 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5
What's the best density for a full cap?
08-19-2011, 07:17 PM,
#5
RE: What's the best density for a full cap?
The Toplace densities are generally a bit higher than what you may be used to. As a guide, medium to heavy is 70-75% [75% on a Toplace system is approx. 100 % on ``other`` system-providers] so , as Justin Tyme was saying, around 70% or possibly a few percent below, would/should be fine.....you can specify varying percentages for different areas on your system as you know. In relation to shedding.....thankfully I`ve never had this issue with any Toplace systems but whether that`s just because of better-quality of hair/manufacture OR care-routine, I`m not sure [ probably a combination of both]. I`m not a fan of frequent washings..there`s no need as your hair should not be `dirty` as such, unless you work in a dusty environment such as a construction site etc.Whenever you ARE washing, use shampoo and conditioner designed for system hair as they are sulfate-free.I AM a big fan of misting with water and using a good leave-in conditioner frequently. Also, using knot-sealer to seal/`lock`the knots helps prevent them becoming undone and hair falling out.....some wearers don`t use it, I always do.....but that`s just me. Have a look at this thread by JamesJr :
http://forum.toplace.com/showthread.php?tid=4489 I`ve been using this product for a while now...... some people have said it`s not sulfate-free etc. but I haven`t noticed any negative effects so far. My more usual one is `Enhance` leave-in conditioner, which also has UV-blocker in it. Available in USA here : http://www.hairdirect.com/store/Ppi-Enha...4Qodvg8mVg and for those in Europe/UK area here : http://www.hair-development.com/details_...ductID=116
I guess the density of your system should/will be governed by your age.... I think the trick for every wearer is to keep it as `age-appropriate` as you can. Paul.
Reply


Messages In This Thread
RE: What's the best density for a full cap? - Paul In Ireland - 08-19-2011, 07:17 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)