+- Toplace USA (https://forum.toplace.com)
+-- Forum: TopLace Forum (https://forum.toplace.com/forumdisplay.php?fid=3)
+--- Forum: General hair replacement discussion (https://forum.toplace.com/forumdisplay.php?fid=4)
+--- Thread: What glues should i try? (/showthread.php?tid=5927)
What glues should i try? - AmericanJambo - 10-19-2013
Ok, so Iam about to get my first couple pieces. Template is finished and will be shipped out tomorrow. While I'm waiting for my pieces I I'll be gathering the necessary accessories and what not. My question is about what glues to try, obviously.
So, I'm very active. I workout 5 days a week. I have oily skin and I tend to sweat a lot, especially when I sleep. I'd like to only have to detach/reattach once a week at the most. I'm going to start off my first bond with ORWG. I have ordered lace units with poly back and sides. My intention is to do a parameter bond and obviously front hairline, and not a full bond because the cleanup seems easier and if it holds just as well then why bother with a full bond? Unless someone can give me good reasons why I should do a full bond instead. I hate having the top of my head touched anyway, even why I had a full head of hair so touch isn't a problem.
Given this info, what other glues should I try? If any. I would LOVE to get a two week bond but I want to be realistic. Especially with my oily skin and sweating.
Thanks guys!
RE: What glues should i try? - Hersute - 10-19-2013
There is a theory that having a full bond actually causes less shedding, but its not a totally proven thing.
As for glues, they're like frogs, you'll have to kiss a few before you find a prince.
I like the NX GEN by HairDirect.
You might think its expensive but one bottle has lasted me 6 months and I still have a quarter of the bottle left.
Ghostbond XL gets good reviews but I think you have to also buy the GhostBuster to remove it and do an easier clean up.
RE: What glues should i try? - AmericanJambo - 10-20-2013
Thanks Hersute. I know that glues really depend upon your body chemistry. I was just wondering what everyone's recommendations where so I had someplace to start.
Do you do a full bond or a parameter bond? What's the cleanup like for the NX GEN? And finally are both NX GEN and Ghostbond XL both ok to use on poly? Thanks again!
RE: What glues should i try? - Hersute - 10-20-2013
I've always done a full bond.
With lace it was ORWG and with the Ultra Thin Skin its NX GEN.
I've never had a poly perimeter but I see no problems using any glue on that.
To clean up, I soak my systems in a shallow bowl of Autoglym Intensive tar Remover (20-30 mins) and the glue turns to jelly and comes straight off.