Hello There, Guest! Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thin Skin Stock Unit Color
11-04-2013, 11:31 PM,
#13
RE: Thin Skin Stock Unit Color
Hi Rainman
The cut-in is made by a professional hairdresser near where I’m living.
Normally my wife attach me and shorten the hair on the unit the evening, and early the next morning I go to the hairdresser with a cap ;-)
I attach my unit with glue, a full bond: Magnetic Jack (an Italian product similar to Ultra Hold) for the first 2.5 cm (1 inch) on the front and Ghost Bond for the rest. Now I ordered Endura-Bond from TL to test this product for the front, I will give a feedback abut that after the next attachment.
At the beginning I used Ghost Bond (water based glow) for the entire unit, but after I made some sport, by washing the hair the front secede a little bit. And because this I decide to switch to non water based glow for the front.
The reason why I use a water based glow for the rest of the unit, is why if for some reasons the glues comes out from the unit to my hairs, is easier to clean it out with a little bit of shampoo and I don’t need some special remover. And also why for my wife is easier to manage with a water based glow than manage with more strong glues like ultra hold.
Can be that the forum experts have better suggestion about to make the attachment, but at the moment for me this is the best solution!?
I appreciate suggestions about to improve my attachment, for me is important a minimum held of 4 weeks or more also on doing sport (cycling).
Regards
Alessandro
Reply


Messages In This Thread
Thin Skin Stock Unit Color - alessandro - 10-31-2013, 09:52 AM
RE: Thin Skin Stock Unit Color - Hersute - 10-31-2013, 01:31 PM
RE: Thin Skin Stock Unit Color - Hersute - 10-31-2013, 09:04 PM
RE: Thin Skin Stock Unit Color - Hersute - 10-31-2013, 11:38 PM
RE: Thin Skin Stock Unit Color - Baldrich - 11-01-2013, 01:09 AM
RE: Thin Skin Stock Unit Color - Baldrich - 11-01-2013, 03:33 AM
RE: Thin Skin Stock Unit Color - Hersute - 11-01-2013, 05:09 AM
RE: Thin Skin Stock Unit Color - rainman54 - 11-03-2013, 06:24 AM
RE: Thin Skin Stock Unit Color - alessandro - 11-04-2013, 11:31 PM
RE: Thin Skin Stock Unit Color - Borja - 11-07-2013, 01:07 AM
RE: Thin Skin Stock Unit Color - Hersute - 11-18-2013, 08:50 AM
RE: Thin Skin Stock Unit Color - Baldrich - 11-18-2013, 04:35 PM
RE: Thin Skin Stock Unit Color - Hersute - 11-25-2013, 01:48 AM
RE: Thin Skin Stock Unit Color - Baldrich - 11-28-2013, 01:43 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)