Hello There, Guest! Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
visible line at front
12-18-2012, 08:35 AM,
#11
RE: visible line at front
or you can shave that thining hair and replace it ?
Reply
12-18-2012, 09:08 AM,
#12
RE: visible line at front
Hey Mathew, John from Toplace has already chimmed in with his input, he is probably already aware. If not send him the link of this thread and he will know exactly what its all about. Mathew remember one thing, this is a potential solution but not the best. Eventually you will have to cut the front and go with a full . On the other hand a piece does not last forever so you can try the graduating front hairline and once you notice the front thinning out to much just order the full and you will be ok.
Reply
12-18-2012, 04:28 PM,
#13
RE: visible line at front
I'd recommend sending photos that show your current natural density and the density of the unit you are wearing in along with your order. This will give the factory a good visual reference to follow when creating and graduating your unit.

It would be extremely hard to specify a correct numerical density on an order form alone for a good match/blend in this situation.

I also agree with everyone else that going with an all lace or lace w/ poly sides unit would be your best choice... Getting rid of that poly in the front will make a world of difference!


Attached Files Image(s)
   
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)