For those of you that do your own hair piece attachments, How do you shave the area where the hair piece goes on? I'm afraid i'm gonna take off too much or something. Is there any trick to this?

thatkid Wrote:For those of you that do your own hair piece attachments, How do you shave the area where the hair piece goes on? I'm afraid i'm gonna take off too much or something. Is there any trick to this?

If you dont want to take to much off, Just mark a line on each side of your head INSIDE were you own hair is growing naturally (Use a marker pen it is easily removed with 99% Alcohol) Then shave in between the 2 lines, Spray on alcohol and remove lines, Jobs a good un.

You'll know after awhile because the hair obviously won't be as long as the areas where the piece isn't.

Otherwise, just look where the glue or tape residue is.

If its your first time, you will need to use the template you made.

JamesKennedy Wrote:You'll know after awhile because the hair obviously won't be as long as the areas where the piece isn't.

Otherwise, just look where the glue or tape residue is.

If its your first time, you will need to use the template you made.

How do you use your template when its at the toplace/china factory?

YuleB Wrote:

JamesKennedy Wrote:You'll know after awhile because the hair obviously won't be as long as the areas where the piece isn't.

Otherwise, just look where the glue or tape residue is.

If its your first time, you will need to use the template you made.

How do you use your template when its at the toplace/china factory?

Make another one mate, Always good to have a spare.

Is there a way to make a templete off your HP? My templete was made by someone who could draw...lol.. I cant and i want it to be the same as how the pieces are coming in