Hello There, Guest! Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Crown and cutting in stock unit
10-23-2008, 12:14 PM,
#4
Re: Crown and cutting in stock unit
well, it is always "best" if you don't ever have to cut into the hairline, however, I've done it many times out of necessity. perhaps try putting your hair piece upside down on a styro head, place the template over it and move it until it is best situated so that your template isn't lining up in a bad spot on the crown.
you may need to move it more to one side , or back a bit further.
DebbieS.
Reply


Messages In This Thread
Crown and cutting in stock unit - Guest - 10-22-2008, 06:33 AM
Re: Crown and cutting in stock unit - Guest - 10-23-2008, 07:14 AM
Re: Crown and cutting in stock unit - DebbieS. - 10-23-2008, 12:14 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)