Over the past few days, I have experimented a bit with the Got2B products on my all Swiss lace full cap. Very interesting stuff...I have the blasting freeze spray and the spiking glue. The spiking glue seems much weaker than the spray and is therefore less useful to me. The spray, on the other hand, has been effective. I usually have a heck of a time getting the nape to stay down, even when I use ultrahold in that area. From reading widely about full caps on various forums and websites, the nape seems to give most full cap wearers the biggest problem. That's certainly been my experience. But where Ultrahold didn't work too well for me, the blasting freeze spray has worked a little better. It makes for a very fast and easy touch up. I can spray a little on my fingertip, stick the finger under the nape area of the unit and in literally 10 seconds have a solid hold again--certainly for the rest of the day. As fast as the touchup is, I don't mind touching up daily. Up until recently, I had to use the ultrahold to touch up and this would take several minutes. And there are no glue boogers with the spray. Today for the first time I tried a full attachment with the spray with the expectation that I will be satisfied to get a 24 hour hold. It was a much quicker process than using ultrahold. And the finished look, in my opinion, is better than with either white glue or UH. There is a better "hair growing out of scalp" effect. I know there is going to be a major downside to this product, but I have yet to experience it. Cleanup? Sudden lace lift? I should know within a week. Oh there is one downside---with a full cap and so much surface to bond, you have to work very very quickly because the spray dries superfast. When I applied today, I had to add spray twice because it was dry by the time I got to part of the perimeter.