Xeon,

Here's the attachment :

1) Make sure scalp is bone dry. Not necessary, but I do an alcohol wipe down & let dry
2) Squeeze out some of the spiking glue & work it to a "just slightly white" thickness layer over the whole bald area
3) Start from front or back according to your preference & start to slightly stretch around the perimeter
** NOTE ** I did it back to front for the first time & my back/sides are the best, most flush to the "line" alignment Ive done so far
4) Take a comb and get betwix the hairs & press down the hairline
5) Take a towel and pull down snug on the whole thing ( except the hairline)
6) Give it a few minutes & go back over the hairline & whole thing with a proper brush to free any hairs that got pressed into the "glue". Since it doesn't stay tacky, it's easy.

Now I'm doing this with a full lace......if you're using any type of skin, I would imagine a RIDICULOUSLY tight bond!