Hello There, Guest! Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
My hairpiece after cut in (photo)
09-05-2013, 06:32 AM,
#4
RE: My hairpiece after cut in
Nice style ..suits you and no knot-visibility as I said in the other thread.... your system is new and the hair is still ` good` ..... it will, over time, become less ` springy` and you`ll find Brylcreem won`t be as effective.. I used to use it a lot, but I find regular application/s of it leads to build-up and the hair begins to look lifeless...you end up shampooing it out and then the process begins again.....you may find a leave-in conditioner works better for you for regular use....you could use the Brylcreem for ` special` occasions to add that lustre -look...... I use ``PPI Enhance`` leave -in conditioner.... no build-up, cheap to buy [shipping can be expensive depending where you live] and it`s also got sunscreen in it...... it has the same viscosity as water ... I back-brush the hair , mist it with water, and then add a few darts of Enhance.... lightly style the hair and allow to dry naturally..you can add a light finishing-coat when the hair is almost dry.....it provides a light ` hold` which brushes out . I used to use all kinds of ` product` on my systems but I always ended up looking like a grease-ball with lifeless hair, and I had to shampoo too often..this then lifted the colour and dried the hair...... once I discovered Enhance, I`ve never looked back and only shampoo the hair infrequently ! I attribute the relatively long-life of my systems to using that and also, because I don`t sleep with the system on...... a few people who bought it and used it on their systems said it prolonged the life-span.
If you just Google `` PPI Enhance`` or ` PPI Enhance conditioner` you`ll find the suppliers.
Enjoy your new hair and welcome to this [sometimes crazy !] world of wearing.
Reply


Messages In This Thread
RE: My hairpiece after cut in - antywanty - 09-05-2013, 05:27 AM
RE: My hairpiece after cut in - Paul In Ireland - 09-05-2013, 06:32 AM

Forum Jump:


Users browsing this thread: 6 Guest(s)