Again, thank you so much for taking the time to answer my questions! There are lots of them.


This is really hard!!

Were at my hairdresser yesterday to make an attempt to get everything in place, but it didnt went to good. It is really really hard to know when you still have hair on my head, where to shave that off.

I made a custom fit temple but I think the system I got home not at all consistent with the template I posted. Well, that's not the point. But how do you know where to shave off their hair? It makes it even harder when you are light in the hair.

We glued it yesterday but did not quite cut it, but the bonding got a little wrong plus I had no time to wash it before so now I have taken the system of and washed it twice to get rid of that silicone spray they put on it when they are shipping it. But is it normal that it sticks much hair from the system in the glue on the head?
It made it now and I do not really know how I will do to take it off properly. I have purchased and used the lace release but do not really understand if I should spray it on the scalp, or if I should spray it at the edge while I draw the system off?

The jammed barely any glue on the system, which may be good? But everything was stuck on mine head and it was SUPER HARD to get it away? Are there any tricks?

How much glue to use? I bought the NX-Gen Unifying Agent glue and you should put on four layers, but I thought it seemed VERY shiny? Have I used too much?

I know that I should not wash the system so often, but is it ok to rinse it in water every day when you shower? And how do you do when using got2bglued, you almost need to wet the system each time you glue it?