I only saw your post now [25th] Is it possible to post a pic of your front area? If you only want a partial just enough to cover a small area, I`d suggest using a piece of light cardboard such as from a breakfast cereal box, and cut a piece to approximately the size/ shape of the area you want covered. When you are satisfied you have the required size, wrap a few layers of cling- film over it and make it more rigid with strips of tape [ sellotape is fine] Then just slit the edge to release / take out the cardboard --you can trim the edge and the excess layer of film underneath, so you are just left with the top bit ----- i`m probably making it sound complex --it`s not. When you make a `normal`template for a system, you first place a large piece of film over the bald area and long enough to allow you tie it under you chin to hold it in place while you apply layers of sellotape and/or more film. With a small partial, you`ll only be needing a small-ish, maybe oval -shaped template. It would be hard to try to place a few layers of tape in alternate directions on a loose piece of film and have the thing to sit obediently while you work ! The use of a piece of cardboard, the correct size and area, will allow you to wrap some film around it, make it rigid with layers of tape, and you can then just discard the piece of card --I hope you get the idea anyway --sorry for being long-winded !! The type of hair you now have will dictate your style on the order --if it`s short, straight, wavy etc. If you want the hair to be `tightly` forward, mark the template with some arrows showing your preferred hair -direction and the factory will ventilate the hair as you request. You might consider freestyle which will tend to take on or `lean`to whatever way you style/comb it and after a little wear and it settles in, put a very very light coat of knot -sealer on the knots ( the underside of the system )and this will also help `lock`the hair into lying a particular way. I hope that helps -- Paul.