Hello There, Guest! Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Great item to have on hand!
12-26-2009, 06:24 AM,
#1
Great item to have on hand!
There are certain products that are great to have around to 'finish' your look. It's always a good idea to have a razor comb on hand for doing those subtle trims so that your own hair gradually blends in with the hair system. Debbie sells a Professional Razor Comb on her site for only $10.99 plus S&H. Check it out.
Regards,
John
Reply
12-27-2009, 02:56 AM,
#2
Re: Great item to have on hand!
sorry for this dumb question, but how does it work?
Does it cut your hair on the sides as you comb?
Reply
12-27-2009, 05:25 AM,
#3
Re: Great item to have on hand!
Yes, it's a comb with a razor in it. As you comb your hair the razor cuts off a small amount of hair. It makes a smooth and even cut. If you want to keep on cutting more hair off you just keep on combing till you get the desired result.
Reply
12-27-2009, 03:44 PM,
#4
Re: Great item to have on hand!
I will caution new users that to be very careful with this device, it is great but you can butcher a piece with one swipe.

Practice with an old piece or when your new piece is longer. Big Grin

Gel is a master with this and don't be afraid to offer up a post requesting his techniques and advice.
Reply
12-28-2009, 07:46 PM,
#5
Re: Great item to have on hand!
I've got one of those and use it sometimes, though I prefer to use simple Bic disposable shaving razors. Cheap and readily available there's less risk of cutting off too much at once. You may go through a few of them to cut in and blend one unit as the hair tends to clog the razor, but they work a treat and are easy to use.
Reply
12-30-2009, 03:19 PM,
#6
Re: Great item to have on hand!
I have something similar in my box of goodies. It was even handier when I wore a smaller unit, but even with the full cap I have used it to knock down "high points" whenever necessary. Just make sure you only take a little off at a time and you'll be ok.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)