I am using ultra hold and it isnt holding great at the front and I think i may be using 2 much as it is coming through the lace, Also how do you clean the glue from the lace as the ultra hold doesnt dry? Thanks for any replies

Hey Tunners,

I have been told the best way to get the ultra hold from the lace is to put some pure adhesive removal on a cotton ball and and pinch the glue off the base.

I get the same problem with UH, seeps through the base no matter how long I let it dry or how thin the coat is. A soon as you sweat or meet with some water the glue will obviously bleed through.

According to Michigan baldy we only need one very thin layer of the stuff. I have done this and still bleeds through. I am going to try a skin base soon.

What if you try putting tape a cm or two from your hair line and then some glue infront of that? That way you minimize the glue you use and less bleed through will happen.

tunners


like downundersyd said may be your just putting to much ultra hold on and not letting it dry . i use ultra i put
2 small coats of it on and its well nearly dry when i put the piece on and it holds fine

jake

austin is a great place )

wow i never really wait that long before i push down on the ultra hold glue. Say if the weather isnt very warm how long on average should i have to wait before i push the lace down on the glued scalp?