Hello There, Guest! Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Ready to do a cut-in myself
04-14-2017, 10:29 AM,
#1
Ready to do a cut-in myself
I want to shorten a system that's 4-5 inches in length. The plan is to use a Flowbee vacuum trimmer to cut the length down to 1.5 to 2 inches all over and then blend the fringe using thinning shears and a razor comb. The HS is SFS lace and medium density (scalp is visible). Does this sound reasonable? This is my first attempt at this and I don't want to mess up an otherwise good system. Thanks.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)