Hello There, Guest! Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Help me finish up the template (photos)
03-13-2011, 09:44 AM,
#2
RE: Help me finish up the template
Hi Val.. I`d `round`the front a little...it`s kind of a V shape...... just looking at the back there [trying to see through the film] I`d enclose that pic too and mark your crown-point inside the inner black line..... draw arrows on it to show the desired hair -direction ... just cut out the template leaving maybe half an inch excess/outside the black line....sit it on your head to see how it looks,and you can gradually trim it in further if you wish, until you`re happy with the final shape...I`d prefer to cut / trim my template to the correct size than to trim my system ANY day. I`ve `lifted`the pic there and will mark some lines on it to help you ....I`ll re -post it below here ... as for the densities... as John said... if they think it will be `off` they`ll contact John and he can advise you .... the main thing is to make sure you`re happy with the finished template before submitting it ....pop in a few pics as you did in your first thread ...it will help them see what way your hair grows and your receded temples etc.... just `tidy up` your template when you have it cut out..Paul.
OK -- hope this explains better what I mean ...


Attached Files Image(s)
   
Reply


Messages In This Thread
RE: Help me finish up the template - Paul In Ireland - 03-13-2011, 09:44 AM
RE: Help me finish up the template - Val - 03-14-2011, 12:30 AM
RE: Help me finish up the template - Henry - 03-14-2011, 01:03 AM
RE: Help me finish up the template - Val - 03-14-2011, 11:41 AM
RE: Help me finish up the template - LTB - 03-15-2011, 07:47 AM
RE: Help me finish up the template - Val - 03-15-2011, 08:04 AM
RE: Help me finish up the template - LTB - 03-15-2011, 09:25 AM
RE: Help me finish up the template - Val - 03-15-2011, 08:43 PM
RE: Help me finish up the template - Val - 03-15-2011, 10:31 PM
RE: Help me finish up the template - LTB - 03-16-2011, 03:48 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)